Home » Blog » How to Apply Transmission Fluids in automatic transmission

How to Apply Transmission Fluids in automatic transmission

    Is adding Transmission Fluid (TF) as a lead additive really effective?

    The lead additive has become a common practice in the automotive industry. This is because it helps reduce friction between the metal surfaces and the lubricant. As a result, it reduces wear and tear on the parts.

    It also increases the service life of the engine by reducing fuel consumption and increasing efficiency. In addition to that, it improves the performance of the vehicle.

    However, there are some disadvantages associated with using this type of additive. One of them is that it can cause corrosion of the engine if not used properly. It is recommended that you use an approved TF for your car.

    Here’s how to choose the right one:

    1. The first thing you need to check when choosing a TF is its pH level. If it’s too high, then it will corrode the engine. On the other hand, if it’s too low, then it won’t do much good. You should be able to find a suitable TF at any auto shop or even online.

    2. Another important factor to consider is the viscosity level. A higher viscosity means that the TF will stay longer on the surface of the engine. This makes it easier to clean up after each oil change. However, a lower viscosity means that it will evaporate faster. So make sure that you choose a TF with the right viscosity.

    3. The last but not least factor to look out for is the density level. The ideal density level is 0.8-0.9 grams per milliliter. This is because it will increase the viscosity of the oil. But if it’s below 0.7 grams per milliliter, then it won‘t work well.

    So now that we know what to look for in a TF, let’s see how to apply it correctly.

     

    How to Apply Transmission Fluids in automatic transmission

    1. Before applying the TF. First off, you have to prepare the area where you want to add the TF. Make sure that it’s dry before applying the TF. Otherwise, it may clog the filters.
    2. Once you’re done preparing the area, start applying the TF. Start from the bottom of the filter and move upwards until you reach the top. Then go back down again and repeat the process.
    3. After you’ve finished applying the TF, wait for about 20 minutes before starting the engine.
    4. After waiting for 20 minutes, start the engine and drive away.
    5. When you stop driving, turn off the ignition switch and remove the key. Then drain all the fluid from the reservoir.
    6. Now, you can begin cleaning the filters. Use a paper towel to wipe away any excess TF left behind.
    7. Repeat steps 2 through 6 every time you change the oil.

    If you follow these simple instructions, then you shouldn’t have any problems using a TF.

    But if you’re still having trouble, then you can always contact us. We’ll help you get rid of the problem quickly!

    How to Add Transmission Fluid to diesel engine

    Transmission Fluid (TF) is a special kind of additive that helps improve the quality of your engine oil. It does this by reducing friction between the metal surfaces in the engine and the lubricating oil. As a result, the engine runs more smoothly and efficiently.

    1. Park your car on flat ground and open the hood to check the dipstick.
    2. Use the dipstick to check the oil level. Wipe off any excess oil before you put the stick back in.
    3. Put the funnel into the dipstick tube. Pour transmission oil into the funnel until the level reaches the full mark on the stick. Pull the funnel out of the dipstick. Reinsert the dipstick. Close the hood.

    Automatic transmissions work by pumping fluid into the transmission pan. The fluid bonds to all of the interior parts to prevent excessive heat frictions. Changing the automatic transmission fluid every 50,000-75,000 miles helps to prevent the fluid from degrading.

    [Total: 1 Average: 5]

    Leave a Reply

    Your email address will not be published. Required fields are marked *